Wagan ProLine Manuel d'utilisateur télécharger pdf (Page 5)

User’s Manual—Read before using this equipment

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

AMPS BAR GRAPH:

This display indicates actual DC amperes of current being drawn from the battery

bank. Note that the AMPS display indicates a range of 120 to 600 amps. Current

less than 120 amps is not displayed. Note that for a 120 Amp reading the inverter

should be powering 1,200 watts of AC load.

FOUR 115V AC OUTLETS

Each outlet will supply 15 amps, 115V AC maximum for powering appliances.

Greater than 1,650 watts continuous power from an outlet may cause damage to

the inverter and cause possible injury.

HIGH OUTPUT AC TERMINALS

There are three insulated terminals on the front panel of the inverter. These terminals

are for connecting 115 volt AC devices that require more than 15 amps to operate.

Other uses are for connection to distributed wiring that has multiple AC outlets. Any

wiring that is directly connected must be 10 gage or larger. Facing the front panel,

the terminals are:

Left Middle Right

Earth (Ground) Neutral Live (Hot)

NEUTRAL and EARTH are bonded inside the inverter to comply with the National

Electric Code (NEC) requirement that any AC source must have a neutral to

ground connection.

REMOTE ON/OFF SWITCH CONNECTION

A supplied cable and Remote Switch assembly provides a convenient remote

On/Off feature.

POWER INVERTER OUTPUT WAVEFORM

This inverter’s AC output is a modified sine wave (MSW) 115 volts AC. The

comparison of modified sine wave and household AC is shown in the figure below.

Sine Wave

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Wagan ProLine Manuel d'utilisateur Page 5