Wagan 2253 Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
3-IN-1 Easy Air Compressor by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
_______________________________________________________________________________________________________________________
Thank you for purchasing the 3-In-1 Easy air
compressor by Wagan Tech. With normal care and
proper treatment it will provide years of reliable service.
Please read all operating instructions carefully before
use.
AIR COMPRESSOR OPERATION:
Pull out hose from compartment. Place quick connect
chuck over valve stem of tire with thumb lever in the
vertical position (see Figure 1). Push down firmly and
lock into place by pressing thumb lever to horizontal
position (see Figure 2). Turn compressor's switch on
and monitor pressure using the built-in pressure gauge.
DO NOT OVERINFLATE PRODUCTS BEYOND THE
MANUFACTURER'S RECOMMENDATIONS.
When desired pressure is reached, turn off compressor
and disconnect hose.
NOTE: If tire is completely deflated, it is possible that
the seal between the tire and the rim could be broken
allowing air to leak out when trying to inflate. This
usually happens only on completely flat tires. In the
event this situation occurs, you will have to jack up your
car prior to inflating the tire. For inflating other articles,
select the appropriate adaptor and insert into the hose
nozzle as shown. Inflate as illustrated.
NOTE: For athletic balls, moisten needle before
inserting it into the ball valve. For other pneumatic
articles, the nozzle should be inserted into valve and
held tightly to insure a good seal.
CAUTION: NEVER LEAVE COMPRESSOR
UNATTENED WHILE IN USE
Worklight :
The 3-in-1 Easy Air Compressor comes with a built-in
12V 3W adjustable angle worklight. Once the 3-in-1
Easy Air Compressor is connected to a 12V power
outlet, just move the switch to the LIGHT position for a
simple use.
Changing the 12V 3W light bulb:
Unscrew ring from front of light moving anti clockwise.
Unscrew bulb and replace with a new one. Place ring
and lens on the unit by turning it clockwise.
SPECIFICATION:
Pressure Reader................ Reading gauge at 261 PSI,
but can be pumped up to
275 PSI
Air Hose..............................14"
12Volt Cord.........................1.25"
Accessories..........................3 Nozzles, collar, Inflator
Nozzl
Figure 1
Figure 2
e, Sport Needle
www.wagan.com
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
Printed in China
© 2004 Wagan Corporation.
2
Flow rate............................12.5 ~ 15L / min
Vue de la page 1
1 2

Commentaires sur ces manuels

Pas de commentaire